Test for Ozone Levels
The ozone levels within six inches of the AirGem 3000 outlet vent were .02 ppm which is the same as forest air. The ambient levels within the room were .01 ppm. With the new AHPCO™ Cell, oxidation is performed by super oxide ions, hydroxide ions, and hydro peroxide ions in air vapor rather than strong and dangerous ozone. The ambient levels in the average home will be in the ppb (parts per billion) range which is well below the FDA safety limit of 0.04 ppm (parts per million).
Odour reduction
AirGem units have been shown to reduce odours by at least 40% in as little as four hours.
Bacteria, mold and yeast reduction
Test results have shown that AirGem units can reduce mold, yeast and bacteria by as much as 98% in the ambient air of your home.
VOC reduction
Test results have shown that AirGem units can reduce VOCs by as much as 98% in short periods of time.
AirGem Lab Test for Bacteria, Mould and Yeast
Before Air Treatment
|
After Air Treatment
|
|
Test Supervised By
|
Independent Consultant
|
|
Device Tested
|
AirGemTM 3000
|
|
Test Procedure
|
The device was operated as directed under normal household conditions. Five replicate air samples were drawn from an area 13 feet from the device and about 3 feet above the floor at intervals of 8 hours, 30 hours, 54 hours, 102 hours, and 150 hours after start. Standard Petri Dishes were inoculated at each sampling interval. The Air sampler was calibrated to deliver 100 liters of air in one minute and 500 liters of air in five minutes. Inoculated plates were returned promptly to the laboratory for incubation and counting. There were four tests run five different times in different petri dishes in different places throughout the test house.
|
|
Summary
|
After four days:
- Test 1 Mold: 97.7% reduction
- Test 2 Yeast & Mold: 90.9% reduction
- Test 3 Mold: 77.0% reduction
- Test 4 Bacteria*: 34.5% reduction
*Note: Bacteria tests in homes with low ambient bacteria levels will show low percentage drops.
|
|
0870 740 88 35
